Bench Hook

Carpentry, Video by Danny Lipford

If you have ever tried to hand saw a piece of thin wood or molding you know it’s hard to keep it from moving all around. If you clamp it in a vice you could damage the wood, and the routine of clamping and unclamping can often be time consuming. The bench hook provides a stable, easy way to hand saw lumber. It’s called a bench hook because it hooks onto the edge of a bench and acts as a fence to hold the piece of the wood you’re working with. Attach a 1×2 cleat to a 12×18 piece of ½” plywood by screwing (we used 1-inch drywall screws) and gluing it to the bottom edge. Then on the top edge of the plywood use the same technique and attach a 1×3 cleat. Once constructed, set the bench hook in place so that the bottom cleat grabs the edge of your workbench then place the piece of wood you’re working with tightly against the top cleat to get a nice square cut.

You can follow any responses to this entry by subscribing to the news feed with your favorite feed reader. You can leave a comment by skipping to the end of the page. You can trackback to this article from your own site.

One Response to “Bench Hook”

  1. Tom Says:
    December 2nd, 2007 at 11:06 pm

    I like to leave a baseboard overhang on my bench hook so I don’t drag my saw into my bench like the demonstrator did. A bench hook is a sacrificial shop jig…a workbench is not.

Leave a Comment