Expert Advice on Home Improvement TV Host of Emmy®-Nominated Today's Homeowner® and home expert for The Weather ChannelVideo, Carpentry, Repairs and Installation, Tools & Hardware Published 04/23/2008 by Joe Truini
An easy way to drill a hole to a set depth is to simply wrap a piece of making tape around the drill bit and stick the two ends together to form a “flag” on one side of the bit.
Stop drilling when the tape brushes away the shaving, indicating that the desired depth has been reached.
Since the tape will tend to wear out after a few holes, a more permanent solution is to drill a hole lengthwise through a piece of 1” x 1” stock and slide it over the drill bit to act as a stop.
Adjust the bit in the chuck so it protrudes the desired length from the end of the block, then hold the block firmly on the surface and push the drill through it into the wood until the bit bottoms out.
Today's Homeowner with Danny Lipford® is brought to you by:
