Expert Advice on Home Improvement
How To • Videos • Lawn & Garden • DIY • Articles
Indoor Water Savings
By: Danny Lipford 
A plumbing leak can cost you hundreds of dollars a year in wasted water. A simple toilet leak can use 50 extra gallons of water a day. Since many areas are concerned with water shortages, using some of these common sense tips can benefit us all.
- Check your water meter before and after a 2-hour period when water hasn’t been run in your home. If the reading isn’t exactly the same, you’ve got a leak.
- Place a few drops of food coloring into the toilet tank. If the color leaks into the bowl, replace the flapper.
- Get those dripping faucets repaired. Usually it’s a simple matter of replacing worn washers.
- Don’t use the toilet as a wastebasket or ashtray…and
- Install faucet aerators to slow the flow of water.
Practice these few tips and you’ll not only save water, you’ll save on your monthly water bill as well.
Please Leave a Comment
7 Comments on “Indoor Water Savings”
You can follow comments to this article by subscribing to the RSS news feed with your favorite feed reader.
We want to hear from you! In addition to posting comments on articles and videos, you can also send your comments and questions to us on our contact page or at (800) 946-4420. While we can't answer them all, we may use your question on our Homefront radio show, Today’s Homeowner TV show, or online at dannylipford.com.
You might also like
Today's Homeowner with Danny Lipford® is brought to you by:
May 19th, 2007 at 8:25 pm
I have replaced the flapper on the toilet, but I still have a water leakage. The water refills every ten minutes for about 30 seconds. The flapper seal is hard plastic, should I try a soft putty seal on top of the Plastic ?
Dave
Allen Says:May 22nd, 2007 at 3:05 pm
Dave, I think putty would cause more problems than you want. It might be a better idea to use a neoprene seal instead. However, it may be less of a headache to simply replace the inner workings of the toilet completely. FluidMaster makes a great kit and it’s not too difficult, even if you’re not a plumbing guru.
May 28th, 2007 at 7:26 pm
I have a drip in my bathroom sink. I tried to turn off the water completely from underneath so I could replace the washers. The hot water keeps dripping. Is that indicative of a washer problem or something else?
Thank you
Virginia
May 28th, 2007 at 8:07 pm
Where is the info on the detector or valve that shuts off water if washing machine leaks.
thanks
Nicholas Roussos Says:May 29th, 2007 at 8:55 am
Reising, You can find more information on the FloodSafe Auto-Shutoff Connectors at the bottom of the episode description where they appeared, (630) Affordable Interior Updates. It’s listed under Best New Product.
Allen Says:May 29th, 2007 at 9:41 am
Virginia, if the water keeps dripping after you’ve shut off the water at the valve, it sounds like it is simply an obstruction between the washer and the line of flow. A lot of the time, small bits of debris will get into the lines. When you are replacing the washers, before re-assembling the faucet, very GENTLY open the water valve—not full force—to allow the water to flow and try to clean out the debris. If the water is dripping too much to even attempt replacing the washer, then shut it off at the street.
August 15th, 2009 at 6:27 pm
If you are going to install faucet aerators just make sure that you use low flow faucet aerators. Here is a video and write up on them on danny’s site here http://www.dannylipford.com/home-improvement-video/low-flow-faucet-aerator/